Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[VLAN] MH3rd HD 2, 3, & 4 Players Networking
#8
(01-22-2014, 12:47 PM)zhillan Wrote:
(01-22-2014, 12:31 PM)onelight Wrote:
(01-21-2014, 08:17 AM)zhillan Wrote:
(01-21-2014, 07:04 AM)qilun56757 Wrote: I will try to translate the tutorial later


that link work on me
but just 2 member
3 or 4 member its not tested

this is ipVE vLan 2900
https://www.dropbox.com/sm/create/Vlan.rar

this is link for register
http://www.ipve.com/bbs/register.php

thank you for your reply

2 member succes but sometime get broke
3 member always broke
any solution?
4 member still not tested

Once everyone is signed up for the quest, have everyone ready up but do not start the quest yet. Before you depart on the quest, everyone MUST at roughly the same time reduce their emulation speed to 25%. Coordinate over voice chat. Then the quest master hits square and immediately departs on the quest. This is because during loading for a quest, apparently the connection is very sensitive to latency. If the emulator is running at 25% speed a 200ms latency looks like 50ms to the game code itself. It also allows more time for the load itself if your computer isn't the best. Once the quest loads, everyone needs to set their speed back up to 100%. The easiest way to accomplish this is with the alternate speed hotkey. In 'Game Settings->More settings', under Graphics, set Alternative Speed to 25% on EVERYONE's machines. Then everyone hits ` once (the button to the left of the 1 key) to turn it to 25% and then ` again to turn it back up to 100%. Smooth sailing from there.
Reply


Messages In This Thread
RE: [VLAN] MH3rd HD 2, 3, & 4 Players Networking - by onelight - 01-23-2014, 11:58 AM

Forum Jump: