Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Frame skip interface issue.
#2
If you have frameskip set to auto, the frameskip value is the maximal number of frames to skip.

If you set this to 0, it would mean "skip at most 0 frames." That is the same as frameskip off, so it makes no sense. That's why you're not allowed to configure it that way.

If you want a fixed frameskip at 1 frame, turn off auto. If you want to skip at most 1 frame, but never 2 frames and sometimes 0, turn on auto and set it to 1.

-[Unknown]

By the way, you are not the first person to ask this. What do you expect auto frameskip set to 0 to actually do? I don't even understand that concept. What do you think the 0 means?

I can understand you might not realize it's the maximum allowed frameskip, but what do you think it would indicate otherwise?

-[Unknown]


Messages In This Thread
Frame skip interface issue. - by Nightquaker - 05-10-2014, 03:37 PM
RE: Frame skip interface issue. - by [Unknown] - 05-10-2014, 08:26 PM
RE: Frame skip interface issue. - by Nightquaker - 05-10-2014, 08:44 PM
RE: Frame skip interface issue. - by [Unknown] - 05-11-2014, 05:53 AM
RE: Frame skip interface issue. - by Nightquaker - 05-12-2014, 03:45 AM
RE: Frame skip interface issue. - by [Unknown] - 05-12-2014, 05:20 AM
RE: Frame skip interface issue. - by Nightquaker - 05-12-2014, 03:55 PM
RE: Frame skip interface issue. - by vnctdj - 05-12-2014, 07:17 PM

Forum Jump: